|
The Falcon Predator TX8 is a remote control system with up to 8 outputs operated from the two 4 button remote controls - ideal for use with boot releases, door poppers and remote starters etc.
The six auxilliary outputs will give a continuous 500mA negative output for as long as the button is held down. The lock & unlock outputs will give a 1 second 500mA negative pulse if pressed quickly or a continuous pulse if held down. With the addition of two relays the TX8 can operate any central locking system.
- Two x 4 button remote controls with carbon fibre effect finish
- Six 500mA outputs controllable from remote control
- Low negative lock & unlock outputs (see note 1 below)
- Lock/unlock outputs can be used as additional auxilliary outputs
- Armed ground output for connection of optional engine immobiliser
- Programmable transmitter learning
Button 1: Lock & immobiliser output on
Button 2: Unlock & immobiliser output off
Button 3: 1st output
Button 4: 2nd output
Buttons 1 & 3: 3rd output
Buttons 1 & 4: 4th output
Buttons 1 & 2: 5th output
Buttons 3 & 4: 6th output
Note 1. Central Locking
The lock/unlock outputs on this system are low current negative, to control the central locking on most cars you will need two 30 Amp relays. If your central locking system only operates from the drivers door key (not the passengers) then you will also need a 2 wire motor for your drivers door.
Note 2. Auxilliary Outputs
The auxilliary outputs on this system are low current (500mA) negative, to connect a boot release or door poppers a 30 Amp relay will be required for each output used.
Instructions
Installation Instructions
Central Locking Wiring (requires 2 relays)
|
